Category: ‘webbing’

Don’t Forget the Obvious: Basement Self-Rescue

September 25, 2012 Posted by Jason

In our classes we spend a lot of time showing firefighters how to stay out of and how to get out of bad situations.  Our fire service is seeing an increase in firefighters who are falling through floors into basements or sub-levels.  This is large part due to the engineered flooring systems that do not perform well in fire conditions.

Fires are growing more intense much faster than in the past and the structural members of these buildings are under attack before we arrive in some cases.  The importance of knowing our response areas, getting an accurate size-up, doing a 360 evaluation of the building and choosing an appropriate tactic are more critical than ever.

We teach different methods of removing ones self from a basement and removing a downed firefighter from basements.  There are several techniques for removing a firefighter including using an attic ladder, using the hose, rope, or webbing to lift them out of the hole. We can also cut the floor away from the exterior making a window a door to remove someone.  These are just a few examples.

img_1002

For self rescue we teach using a hand tool as a step or as a recent post by Chris Huston discusses, using the drywall as a ladder to get yourself out.  We also teach using webbing as a stepping device with the assistance of firefighters on the outside.  All of these techniques are good and and should be practiced. However, we know that if we fall through a floor we may lose our tools and it is going to be very bad down there. Speed is of the essence.

When go over the teaching points of basement rescues, we always talk about things to do to avoid this from happening in the first place.   Doing a good 360, sound the floors, descend stairs feet first, know your still area and building construction are good places to start.  I also like to point out that the hazards we discuss in regards to basements, junk and clutter, can also be our friend.

 

If you find yourself in a situation in a basement or an area with a high window for egress, use the stuff in that space as steps. Pile it up under that window and climb out.  Don’t forget to use the obvious.  I have done training in acquired structures where we put firefighters in the basement and they are free to use whatever is available. You would be surprised how many limit their resources to only what is in their hands or pockets.

Train hard and sometimes thinking outside the box is as simple as looking around at the “stuff” that is right at your feet.  Thanks for reading and expect fire!

Jason

Drywall Escape Ladder

June 17, 2012 Posted by Jason

Here is a post from our good friend Chris Huston of EngineCo22.  Check out the post and visit him at EngineCo22.net.

 

Options. On the fireground, the more the better. When talking Firefighter Survival, presenting viable options will lead to success. Over the last few years, many great methods of self-rescuing have been taught to the Fire Service. The most important, is staying out of situations that lead to needing them, which is quality performance of the basics. However, after you still did everything right, it can still go bad. Having several techniques to self-rescue is critical to ensure success.

 

One such technique is what I call the Drywall Ladder. This method is performed by kicking and punching holes into the drywall to create a ladder. You would perform this to escape out of high window.

 

The standard residential window is 18”- 44” off the floor, if it meets fire code for escape. Windows higher than 44” are not for egress and are used for lighting and ventilation. To use these windows for self-rescue you have an option or two. The first option if you just need a little “boost”, use your hand-tool to create a step. Halligans work great for this task. Once you are over and out, just make sure to reach back in and grab your tool. If the window is too high, this option may not be feasible.

 

Another option, create a ladder in the drywall. The first step is to determine where the window goes and if refuge can be made. Next, kick a hole into the drywall about 8 inches off the ground then another about knee high. Make sure you create these holes approximately the same width apart as your legs. After the first two holes are created, punch two more holes several inches above the first two with your gloved hand. Think about the distance between two rungs on a ladder. Please use caution when using your body as a tool, consider where the studs are. Can you see the pattern? This method is a distance relative of rock climbing. Be sure to keep your weight on your feet to decrease effort.

 

Other considerations:

  • Call the mayday first and get help coming.
  • Where is the window relative to fire conditions?
  • Will you and your partner physically fit through the window?
  • What type of glass/construction is the window?
  • Will taking the window draw fire towards you?

           

 

Next time you are performing self-rescue maneuvers in training consider trying this method. The more options you have and can quickly utilize one in a self-rescue the better.

Daily Drill: VES

January 19, 2012 Posted by Jason

Here is a post from a very good friend and very wise fireman, Lance Peeples. Lance is a firefighter/paramedic with the Webster Groves Fire Department in St. Louis County. Check it out and give some feed back.

Review the following video and consider how YOUR fire department operates when answering the following questions:

1. Is VES indicated if PPV is used by your department? What safety precaution should the operator of a PPV fan perform before starting the fan?

2. Notice how the VES firefighter enters head first. Very experienced instructors often recommend grasping the window frame with the head and upper body protected by the wall and then entering with the opposite foot. This permits the firefighter to make an emergency ladder slide if necessary.

What is another advantage of this technique?

3. On your first alarm assignment who is the firefighter assigned the responsibility for VES. Who is the firefighter that will assist him in this technique?

4. If the assisting firefighter ascends the ladder to orient the searching firefighter how can the ladder be butted? Does it always need to be butted? Could a tool be driven into the grounds at the butt of the ladder to prevent it from sliding?

5. Are the tools (hook and halligan) needed for VES mounted near the riding position of the member who is responsible for this function or are they mounted on the other side of the apparatus underneath the water rescue rope and drinking cups?

6. Notice how the roof ladder projects into the window slightly. However, the ladder is already at a very low angle that could result in the butt kicking out. Should the ladder tip be removed from the window to allow for easier emergency exit/victim removal or does the angle of the ladder preclude this? What are possible solutions?

7. Some of the commentators below the video are critical of opening the door upon preparing to leave the room…what say you?

Webbing Assisted Basement Removal

November 17, 2011 Posted by Jason

Here is a quick video of how to use a piece of webbing to assist a firefighter out of a basement window. Understand, that depending on the height of the basement, the length of webbing needed may need to be longer. A 30 foot piece of webbing tied in a loop will work for most situations. The reason the loop is used is so if the webbing slips, it wont completely slip out of your hands if your one of the firefighters pulling on the outside.

Thanks for reading and watching and train hard.

Jason

Through the Floor Rescue with a Hose

August 22, 2011 Posted by Jason

Here is a simple and effective method for rescuing a firefighter who has fallen through a floor.  This method uses a charged hose line, that is hopefully very close, to remove a downed firefighter through the floor.

Somebody needs to get down to the firefighter at the level below.  An attic ladder can be used but takes time. We practice sliding the charged hose line like a pole.  You must practice this and really wrap your legs really tight. You will slide down fast.

With the hose in the hole you have some protection to keep fire off of the downed firefighter. Do not disregard that you encounter. It wont matter if you don’t put the fire out and it over runs you.

Once you have determined that the firefighter is unable to get himself out and his air is safe, loosen his SCBA waist straps and convert him through his legs.  Sit the firefighter up and loosen the shoulder straps.  Run the hose line through the should straps above the shoulders behind his head.

      

Feed the hose back up through the hole to a team above.  Make sure to feed enough line for them to pull and lift.  Tighten down the  shoulder straps after enough line has been fed up.

Now the team above needs to pull the hose and lift the firefighter up out of the hole. The firefighter below needs to help guide the firefighter as he goes up.

Understand that the SCBA packs are not rated for rescue operations in relation to harnesses.  These are not made to dangle people off of roofs or out of windows.

We will cover how the rescuer firefighter gets out after the downed firefighter is rescued. Now, go train and give it a try.

Jason

Webbing Harness

August 6, 2011 Posted by Jason

This is just a quick way to use some webbing to make a harness to remove a victim or a downed firefighter.  You need at least a 20 foot piece of webbing and no more than a 30 foot piece. If it is longer it tends to just get in the way.

I will normally keep different lengths in my pockets for different uses. The one that I keep for this type of use is kept looped with a water knot.

For a victim or downed firefighter lay the webbing around the victim.  Grab the webbing at the feet and pull it up between the legs. Hold it tight and grab the webbing on the sides and bring both pieces up under the arms to right over the chest.  You should now have three loops, one from between the legs and two, one from each side, under the arms.

      

Pull the two side loops through the loop coming from between the legs and pull tight.  These are your handles.  Get all webbing tight and snug under the arms and between the legs.

You can now pull and drag your victim. You can also lift a victim up out of a basement window.  Check out the pictures and the attached video.

 

To get the straps on the back of a firefighter or victim, roll them over on their front and perform the same method. You will see this in the video.

 

This does take some time and is just another method that is available to you.  Just another tool in your tool box.

Go train and give it a try.

 

Jason

Searching Off of the Line

June 5, 2011 Posted by Jason

With today’s fire service being cut to the bone, fire departments are finding themselves short handed in every aspect of our day to day functions.  This affects how we operate and it may require us to change how we perform some tasks.

In other areas fire departments have been running “short” since their inception: 3-man crews.  They have never had the man power to separate functions like fire attack and search.  They have always had to  and continue to adapt to the resources that are available.

In my part of the country, the second example is by and large the most prevelant. The majority of departments that are not volunteer operate with 3 person crews. That includes the driver.  This obviously creates some challenges and some adaptability to each situation.

One area is searching buildings.  The best way to protect victims and icnrease their survivability is to improve the atmosphere by putting out the fire and venting to let toxic gas, heat and smoke to be evacuated out of the building.

However, there are many instances that require us to physically find and remove victims from burning buildings.

Many areas are seeing large homes that are difficult to use traditional wall searches because we are not getting to the middle of the room.  This becomes a challenge also due to the many doors and additional rooms that these buildings contain.

One method that we teach and practice is searching off of the hose line with a length of webbing.  The initial crew can stretch a line and search at the same time. Is it a little slower? Sure, but they can perform both functions effectively if they train properly.  What is important is that they understand that they must put out the fire if they come to it first and remove the victim if they find them first.

When searching with a line one firefighter can tie a girth hitch onto the hose and advance with it. When they get to an area large or cut up, they extend off of the hose line while holding the webbing and staying in voice contact with the nozzle firefighter.

Depending on the length of the webbing the search firefighter can cover a lot of area in a very short time without ever losing contact with the hose.  The nozzle firefighter can continue to watch for changing conditions and has the ability to push back fire if encountered.

This is just one method that can be used in these instances.  You must train and practice to your department’s guidelines. If you have techniques and methods that you use, please share them.

Stay safe and train often.

  • Enter your email address to subscribe to this blog and receive notifications of new posts by email.

  • Find Us On Facebook

  • T-Shirts

    Sizes